Wing Walk Installation
Forum rules
A forum for Panther aircraft builders and Enthusiasts. Two simple rules: Play nice and use a real name
A forum for Panther aircraft builders and Enthusiasts. Two simple rules: Play nice and use a real name
-
danweseman
- Posts: 133
- Joined: Sun May 19, 2013 9:18 pm
- First Name: dan
- Last Name: weseman
- State or Province:
Re: Wing Walk Installation
Dan , fit it now up drill and dimples etc. Do not rivet or trim at this time. it will be trimmed and be the wing to fuse gap faring in this area . it will get trimmed during rigging the wings.
Dan Weseman
Designer
Builder
Test pilot
Panther 515XP
Designer
Builder
Test pilot
Panther 515XP
-
PlaneDan
- Posts: 241
- Joined: Sun Nov 17, 2013 11:52 am
- First Name: Daniel
- Last Name: Heath
- City or Town: Lexington
- State or Province: SC USA
- Location: Lexington, SC USA
- Contact:
Wing Walk Installation
I am working on fitting the wing walk to the pre-punched holes. I see that the inboard edge of the walk, extends beyond the skin. Is this how it should be? If not, should I be trimming it to the inboard edge of the skin?
PantherBuilder.org