Nameplate Engravings
Posted: Wed Aug 25, 2021 7:50 pm
I created a few nameplate/engravings that are being worked on by Aircraft Engravers out of CT. Good crew, but a little expensive if you make them to complex which takes more hours to produce. They are only .020" thick v. .065" and up, so cost is more.
The 1st nameplate is the typical side wall mounted plate that shows Trim/Throttle and Mixture. If you chose the standard BM quadrant this will work for you too.
The other three nameplates are specific to my Instrument panel layout but includes information that may be used in your own layout.
DXF Files are available by DM.
If anyone wants me to do a nameplate file, I am offering drafting services, just DM me.
The 1st nameplate is the typical side wall mounted plate that shows Trim/Throttle and Mixture. If you chose the standard BM quadrant this will work for you too.
The other three nameplates are specific to my Instrument panel layout but includes information that may be used in your own layout.
DXF Files are available by DM.
If anyone wants me to do a nameplate file, I am offering drafting services, just DM me.