Panther Sport Aircraft Forums

Guys
these holes were not in the stiffener or the channel , but shown on plans page P-T-HT?VT-spar details ,and several places on P-T-HT-Details.
We have verified the file and future parts will have these holes.

I let Dan know this via phone. They are going to ammend plans to add two holes. Should be there. Just use rib as template.

After looking at the HT spars again it looks like only the center holes for the inner ribs are missing on the spars, top and bottom holes are there.

rick h

Question about the predrilled holes in the HT front and rear spars for the ribs, there are no holes for the two inner ribs (are shown on the plans). Are we supposed to cleco the skins on first to figure out where these holes are to be drilled in the spars?

thanks

rick h