How much frame sealant needed?

General Panther Building Discussion
Forum rules
A forum for Panther aircraft builders and Enthusiasts. Two simple rules: Play nice and use a real name
Post Reply
User avatar
tomkk
Posts: 32
Joined: Tue May 30, 2017 7:18 pm
First Name: Tom
Last Name: Kodey
City or Town: Port Orange
State or Province: FL

Re: How much frame sealant needed?

Post by tomkk »

I did it with one tube but it was tight ...
Tom
Port Orange, Fl
Panther #104 (1st flight March 13, 2020, 72 hrs as of July 15, 2020)
RV-12 (1st flight June 10, 2015)
RV-12 (Eagles Nest 1st flight May 18, 2019)
Top
psalter
Posts: 146
Joined: Sun May 19, 2013 6:50 pm
First Name: Paul
Last Name: Salter
State or Province:
Location: Green Cove Springs, Florida

Re: How much frame sealant needed?

Post by psalter »

I used 2 tubes for all of the skins that are against the steel, firewall included. But part of that was because I put the skins on at different times and it dried out on me. So I wouldn't buy too much right now if you are only putting on a few skins. But I believe you will need more than one.

Paul
Paul Salter
Team Panther
Engineer and Builder
Top
User avatar
RonFranck
Posts: 84
Joined: Sat May 25, 2013 7:55 am
First Name: Ron
Last Name: Franck
City or Town: Cambridge
State or Province: IL
Location: Cambridge, IL, USA
Contact:
Contact RonFranck

How much frame sealant needed?

Post by RonFranck »

I'm about to place an order with Aircraft Spruce and Specialties for some Aerolife single component polyprotech sealant as suggested in the builder's manual for use where the fuselage skins attach to the chrome-moly framework. Each tube of sealant contains about 5 oz. of sealant. Will one tube be sufficient or do I need to order multiple tubes? :?:
I assume it is used on all exterior skins, bottom, both L and R sides and possibly the firewall, or is it not suitable or needed for the firewall?
Thanks!
Top
Post Reply

Return to “Building a Panther”