Guys
these holes were not in the stiffener or the channel , but shown on plans page P-T-HT?VT-spar details ,and several places on P-T-HT-Details.
We have verified the file and future parts will have these holes.
HT spar holes for inner ribs
Forum rules
A forum for Panther aircraft builders and Enthusiasts. Two simple rules: Play nice and use a real name
A forum for Panther aircraft builders and Enthusiasts. Two simple rules: Play nice and use a real name
-
danweseman
- Posts: 133
- Joined: Sun May 19, 2013 9:18 pm
- First Name: dan
- Last Name: weseman
- State or Province:
Re: HT spar holes for inner ribs
Dan Weseman
Designer
Builder
Test pilot
Panther 515XP
Designer
Builder
Test pilot
Panther 515XP
-
Sacpilot
- Posts: 76
- Joined: Fri Jun 07, 2013 7:46 pm
- First Name: Christopher
- Last Name: Braun
- City or Town: Rocklin
- State or Province: CA
- Location: Rocklin, CA
- Contact:
Re: HT spar holes for inner ribs
I let Dan know this via phone. They are going to ammend plans to add two holes. Should be there. Just use rib as template.
Christopher Braun
CFII - Owner Norcal Flight Center
EAA Lifetime #808722
Panther SN-052
CFII - Owner Norcal Flight Center
EAA Lifetime #808722
Panther SN-052
-
at7000ft
- Posts: 175
- Joined: Sun Apr 13, 2014 4:59 pm
- First Name: RICK
- Last Name: HOLLAND
- City or Town: CASTLE ROCK
- State or Province: Colorado
- Location: Castle Rock, CO
Re: HT spar holes for inner ribs
After looking at the HT spars again it looks like only the center holes for the inner ribs are missing on the spars, top and bottom holes are there.
rick h
rick h
Rick Holland
N6819Z
N6819Z
-
at7000ft
- Posts: 175
- Joined: Sun Apr 13, 2014 4:59 pm
- First Name: RICK
- Last Name: HOLLAND
- City or Town: CASTLE ROCK
- State or Province: Colorado
- Location: Castle Rock, CO
HT spar holes for inner ribs
Question about the predrilled holes in the HT front and rear spars for the ribs, there are no holes for the two inner ribs (are shown on the plans). Are we supposed to cleco the skins on first to figure out where these holes are to be drilled in the spars?
thanks
rick h
thanks
rick h
Rick Holland
N6819Z
N6819Z