Call out for group tool order from Panther builders.
Forum rules
A forum for Panther aircraft builders and Enthusiasts. Two simple rules: Play nice and use a real name
A forum for Panther aircraft builders and Enthusiasts. Two simple rules: Play nice and use a real name
-
Seansull
- Posts: 65
- Joined: Sun Oct 05, 2014 8:08 pm
- First Name: Sean
- Last Name: Sullivan
- City or Town: Fort Worth
- State or Province: TX
- Location: Fort Worth, TX
- Contact:
Re: Call out for group tool order from Panther builders.
How many do you have so far Chris?
Sean Sullivan
Based at KFWS
Fort Worth, TX 76110
Panther Builder SN048
Mine & Brian's Panther Builder Site:
https://www.facebook.com/NTXPantherSquadron
Our "Flight Club" page
https://www.facebook.com/FlightClubSpinks?ref=bookmarks
Based at KFWS
Fort Worth, TX 76110
Panther Builder SN048
Mine & Brian's Panther Builder Site:
https://www.facebook.com/NTXPantherSquadron
Our "Flight Club" page
https://www.facebook.com/FlightClubSpinks?ref=bookmarks
-
Sacpilot
- Posts: 76
- Joined: Fri Jun 07, 2013 7:46 pm
- First Name: Christopher
- Last Name: Braun
- City or Town: Rocklin
- State or Province: CA
- Location: Rocklin, CA
- Contact:
Call out for group tool order from Panther builders.
Hi guys,
I talked to Bob Avery last week bc I was going to order a 5/32 custom dimple die in a 120 for a Pop rivet. Up until now, if you misdrilled a hole, and made it a 5/32 to eliminate an elongated hole, or mismatched hole, you could use a dome rivet, but if you wanted a dimple you are out of luck. You could use a 100 degree 5/32 die for a solid rivet, which may or may not be ok, bc its not exact.
So, if you want to send me an email by Tuesday, 17th,with an email saying you want one, I am going to send a group order to Bob. One was going to be around a $60, I would think we could save 5-10 dollars as a group. He is going to make them custom, which is time consuming.
Send me an email at Christopher.braun @. Gmail.com if you want one.
Thanks.
I talked to Bob Avery last week bc I was going to order a 5/32 custom dimple die in a 120 for a Pop rivet. Up until now, if you misdrilled a hole, and made it a 5/32 to eliminate an elongated hole, or mismatched hole, you could use a dome rivet, but if you wanted a dimple you are out of luck. You could use a 100 degree 5/32 die for a solid rivet, which may or may not be ok, bc its not exact.
So, if you want to send me an email by Tuesday, 17th,with an email saying you want one, I am going to send a group order to Bob. One was going to be around a $60, I would think we could save 5-10 dollars as a group. He is going to make them custom, which is time consuming.
Send me an email at Christopher.braun @. Gmail.com if you want one.
Thanks.
Christopher Braun
CFII - Owner Norcal Flight Center
EAA Lifetime #808722
Panther SN-052
CFII - Owner Norcal Flight Center
EAA Lifetime #808722
Panther SN-052