Prime and Paint

Topics about finishing touches
Forum rules
A forum for Panther aircraft builders and Enthusiasts. Two simple rules: Play nice and use a real name




Greg Pixley
Posts: 17
Joined: Sun Aug 24, 2014 8:05 am
First Name: Greg
Last Name: Pixley
City or Town: Niceville
State or Province: Florida

Re: Prime and Paint

Post by Greg Pixley »

It's an Acrylic Urethane applied over DP50LF Epoxy primer. And your right about Niceville, never thought I'd end up here but it was a great place to raise kids and retire.

Lowrider
Posts: 60
Joined: Thu Aug 27, 2015 1:10 am
First Name: Joe
Last Name: Dickey
City or Town: Sandpoint
State or Province: ID

Re: Prime and Paint

Post by Lowrider »

Greg,

Is that PPG an epoxy paint or primer? I used to live in Niceville when I was a charter member of the 1st SOW...good place to be!!

Greg Pixley
Posts: 17
Joined: Sun Aug 24, 2014 8:05 am
First Name: Greg
Last Name: Pixley
City or Town: Niceville
State or Province: Florida

Re: Prime and Paint

Post by Greg Pixley »

I just finished painting the floor and side panels with Shopline (PPG) and can't tell the difference from powder coat. The color was #34615 #4 Medium Gray. All my painting experience is with PPG so I stayed with what I know and have reducers for. A quart was $60 with hardener but I only used a quarter of that.

Greg Pixley

Steamer
Posts: 8
Joined: Sun Sep 13, 2015 10:09 pm
First Name: Stanley
Last Name: Johnson
City or Town: Placitas
State or Province: New Mexico

Re: Prime and Paint

Post by Steamer »

Glen,

I've had that happen with rattle cans. In my experience it was because the paint had set on the shelf too long.

Stan J.

GlenNJ
Posts: 152
Joined: Sun May 19, 2013 8:11 am
First Name: Glen
Last Name: Robinson
City or Town: Marmora
State or Province: NJ
Location: Marmora, New Jersey

Re: Prime and Paint

Post by GlenNJ »

Mike,
I'll order a couple of cans and give them a try. I'm working on the spars, and I'd like to put a thin mist coat on the pieces. I can't do that with the Moeller chromate, the way it spits and splatters out of the can. All 4 cans I've used did the same thing, from beginning to end of the can.
Glen

User avatar
MikeS.
Posts: 33
Joined: Wed Nov 27, 2013 11:21 am
First Name: Mike
Last Name: Smith
City or Town: Tuscaloosa
State or Province: AL
Location: TCL

Re: Prime and Paint

Post by MikeS. »

Zinc Chromate Primer in rattle can:

http://www.aircraftspruce.com/catalog/c ... ckkey=7822

Part #: 09-00901 is yellow. Part #: 09-00895 is green. $12.75

When finished spraying hold the can upside down and clear out the tube, and wipe off the spray nozzle. Store the cans upside down at room temperature. I've been working out of the same can for over a year with no issues.

Post Reply